Step 1: Prepare your subfloor
Rigid Click Vinyl can be installed on slightly irregular subfloors and makes subfloor preparation unnecessary in most cases. But we still highly recommend checking the installation instructions for further specifications and making sure the surface is dry, level, stable and clean. Remove all existing floor covering before getting started. The quality of your subfloor has a big influence on the final installation result. If the subfloor is not appropriate for the installation of Rigid Click Vinyl, necessary actions should be taken.
Step 2: Add an underlay if needed
Most of our Rigid Vinyl floors have an attached underlay. No need to select the underlay, you can immediately start installing when the preparation of the subfloor is done.
However, if the Rigid Vinyl floor does not have an attached underlay, one must be selected carefully, as it greatly affects the final outcome by providing noise reduction and leveling functions.
Step 3: Collect your tools
Thanks to our convenient click systems, you won’t be needing hundreds of different tools to install your Rigid Click Vinyl floor. Make sure you have this basic equipment:
- Tape measure or folding ruler
- Bevel tool
- Moisture meter
- Pergo installation set
- Pergo underlay system (for floors without underlay attached)
If you don’t have everything at hand, don’t worry! You’ll find all the equipment you need at a nearby well-equipped DIY centre.
Step 4: install your underlay if needed
It’s about to go down! Unfold your Pergo underlay and install the first strip in the same direction as you plan to lay your floor. Gradually add strips of underlay as you progress. Use a thin adhesive tape to connect the underlay strips and avoid overlapping them.
*Not needed for Rigid Vinyl floors with underlay already attached.
Step 5: start laying your rigid click vinyl floor
All our herringbone, plank and tile vinyl floors are easy to install, but the specific installation method may vary depending on the product and the subfloor. It is important to understand the recommended installation method, including any specific tools needed, before beginning the installation process.
By carefully following the instructions, you can ensure a long-lasting, beautiful floor that meets your needs and expectations.
Step 6: cut your vinyl planks
Inevitably, you’ll need to cut a few Rigid Click Vinyl planks while installing them.
To shorten the length of the plank with a straight cut, you can cut the Rigid vinyl floors with the décor side face up, using a special concave vinyl cutting knife. Draw a straight line and use the knife to make a firm cut in the surface. Then break off the plank using both hands.
For any other cuts, you need to saw the planks. Depending on the type of saw, position your plank with the decor side face-up or face-down. Before making the actual cut, use a leftover piece to determine how the cleanest cut can be obtained (decor side face-up or face-down).
Step 7: finish in style and keep it watertight
Almost there! Remove all spacers and install matching skirtings and colour-matched (5-in-1) or aluminium profiles to finish off your flooring project.
Want a watertight finish? Secure the floor with:
Make sure to consult the full installation instructions before you start installing your Rigid vinyl floor.